A13x Bullet Mod (Vore-tex ver.)

The A13x Bullet Mod (Vore-tex ver.) is a revision of the popular A13x Bullet Mod using archery bullet tips and recent versions of the old parts.

Construction

Parts needed

List from Vore-Tex's video tutorial video

• 1x Pilot Dr. Grip（Grip）
• 1x Giotto Turbo Maxi (Body)
• 1x big Veleda White Board Marker (cap)
• 1x Pentel Color Twin (Small cap)
• 1x Edding 661 (cap)
• 1x Pilot SuperGrip (Grip)
• 1x Pentel RSVP (Grip)
• 2x Archery bullet tips

Additional Items

• Celo tape and Electrical tape

Text tutorial

1. Cut ~3.3 cm of the Veleda White Board Marker cap.
2. Disassemble the Giotto Turbo Maxi and cut the front until it's ~1cm
3. Cut your Pilot Dr. Grip grip into 2x 2cm section.
4. Cut your Pentel RSVP grip 2 times: 1 to separate the o-ring and another one at 2/3 of the grip (one part is slightly longer than the other).
5. Cut 2 sections of Pilot SuperGrip grip, 1x 4 stripes and 1x 2 stripes.
6. Put the Archery bullet tips inside the Edding 661 cap (some tape might be necessary).
7. Add these grips on the Edding 661 following this order: 4 stripes of Pilot G2 grip, the smaller section of Pentel RSVP grip, and one side of Pilot Dr. Grip grip.
8. Add these grips on the Veleda White Board Marker cap following this order: the longer section of Pentel RSVP grip turned inside out, 2 sections of Pilot SuperGrip grip, and the last side of Pilot Dr. Grip grip.
9. Put the Archery bullet tips inside the Veleda White Board Marker cap (tape might be necessary to avoid rattling).
10. Add your Pentel RSVP o-ring on the front of the Giotto Turbo Maxi, and add cello tape on the rest of the front.
11. Put the Pentel Color Twin small cap inside the back of the Giotto Turbo Maxi barrel.
12. Connect the Edding 661 cap on the Pentel Color Twin small cap.
13. Connect the old Veleda White Board Marker cap on the front of the old Giotto Turbo Maxi barrel.

Video tutorial

Video tutorial by VORE-TEX.