Dr. So

The Dr. So is a double-sided mod made by Zefia.

Construction

Parts needed

List from the video below

• x2 Smooth Operator (body and caps)
• x2 Pilot Dr. Grip (1 grip and 2 tips)
• x2 Miniso frixion (grips)
• x1 Dong-A Anyball (grip)
• x1 Daiso SuperGrip-style mechanical pencil (grip and barrel)
• x1 Uniball Impact Rt (grip)
• x1 Miniso Aquarelle brush (body)
• x2 O-ring

Additional Items

• Tape

Text tutorial

1. Empty two Typo Smooth Operator barrels, removing the writing assemblies, ink and backplugs. Remove the front barrel sections so the ends accept the caps.
2. Cut both Smooth Operator caps to 2.9 cm.
3. Cut one Dr. Grip grip into two equal halves. Prepare two Dr. Grip tips.
4. Cut two 3-block Miniso Frixion grip sections, two 2-block Anyball sections, two 1-stripe sections of the Daiso SuperGrip-style mechanical-pencil grip, and two 4 mm sections from the front of Impact RT grips.
5. Cut a 1 mm ring from the Miniso Aquarelle brush barrel. Prepare two O-rings.
6. Cut approximately 2.7 cm from the front of the Daiso SuperGrip-style mechanical-pencil barrel to make the centre connector.
7. On each Smooth Operator barrel, fit the Impact RT section, white SuperGrip-style stripe, then Anyball section toward the outer end. Fit a shortened Smooth Operator cap over that end.
8. Fit a Miniso Frixion section over each Dr. Grip tip. Hold the tip at the cap end and cover it with a Dr. Grip grip half to secure it.
9. On the centre connector, fit an O-ring, the Aquarelle ring, then the second O-ring. Insert one end into each Smooth Operator barrel and push the barrels together against the centre decoration.

Video tutorial

Video tutorial by Zefia.