Akiza G3

The Akiza G3 is a personal mod made by JEB spinner Akiza. This tutorial is unofficial because the original tutorial is secret.

Construction

Parts needed

List from the picture below:

• 2x G3 (barrel, grip)
• 1x Pilot G1 (tip)
• 2x Hyperjell (2 grips)
• 1x Zebra Jimnie (cap)
• 1x Anyball (grip)
• 1x Tsukineko Emboss (big cap)
• 1x Gel roller (tip)

Additional Items

• Vinyl tape
• Any other kind of tape
• An insert

Text tutorial

Cropped picture of the non-official tutorial

Preparation

1. Sand the nub and the front of the G3 barrel.
2. Cut the big ring of the Anyball grip, then cut 5 blocks of Anyball grip.
3. Cut ~2 cm out of one Hyperjell grip.
4. Cut the clip of the Jimnie cap.

Assembly

Front side

1. Place the 2 cm of Hyperjell grip on the front of the G3 barrel.
2. Place the big ring of anyball grip on the G1 tip.
3. Place the G1 tip inside the large end of the Emboss cap (it should fit snugly).
4. Connect the Emboss cap to the front of the G3 barrel.
5. Add a ~4 mm vinyl tape stripe on the Emboss cap's base.

Cap side

1. Put 5 blocks of Anyball grip on the Jimnie cap.
2. Place the Gel roller tip inside the Jimnie cap, add the other Hyperjell grip, and then press it inside the cap.
3. Add some tape on the end of the G3 barrel, then connect the Jimnie cap to it.