FR.KG

The FR.KG is a double-sided mod made by FPSB spinner Megas.

Construction for V1

Parts needed

List from FPSB V5:

• 2x Kacogreen (body)
• 1x Dong-A Anyball (grip)
  • Can be substituted with a G2 grip
• 2x Flying Tiger Copenhagen pen (grips)
• 2x Bic Round Stic (body)
• 2x Screw M3.5 for computers
• 4x O-ring

Text tutorial

Preparation

1. Cut both Kacogreen bodies to 9.5 cm.
2. Cut 1 cm from the leftover Kacogreen body.
3. Cut 1 block of 4 stripes on both Flying Tiger grips.
4. Cut around 3 cm of Bic Round Stic.
5. Cut 2x 2 block of Anyball grip.

Assembly

1. On the KG body, add: 4 stripes of Flying tiger grip, 2 O-rings and the big part of Flying tiger grip.
2. Put 2 blocks of Anyball around the screw.
3. Put the screw inside the Flying tiger grip.
4. Repeat on the other KG body.
5. Put 1cm of KG body and 2 O-rings on the Bic Round Stic and connect.

Construction: reproduced Twitter version

This version follows Megas’s Twitter construction as reproduced by Penmodding.pm; it differs from the FPSB V1 above.

Parts needed

• 2 Kacogreen pens (Barrels and one emptied clicker)
• 1 Anyball grip
• 2 G2 or SuperGrip grips
• 4 clear and 2 black Tect2Way grip rings, or suitable replacement rings
• 2 M3.5 computer screws or Signo tips

Assembly

1. Disassemble both Kacogreen pens. Remove the barrel clips and retain one clicker, removing its internal mechanism.
2. Cut two 9 cm barrel sections from the rear ends and a separate 1.2 cm sleeve from the leftover barrel material.
3. Remove the small ring from the retained clicker. Fit the 1.2 cm barrel sleeve over the clicker, with a grip ring on each side, then join the two 9 cm barrels using this clicker.
4. Cut two 3-block and two 2-block Anyball sections.
5. At each outer barrel end, fit a 3-block Anyball section, two clear rings, and a complete G2 grip. SuperGrip may be used as a substitute.
6. Put a 2-block Anyball section inside the outer grip and insert the screw or tip into it.
7. Repeat at the other end.