Kzzn Emboss: Difference between revisions
From Fen Spinner Wiki
More actions
No edit summary |
wip and unfinished |
||
| Line 26: | Line 26: | ||
===Text Tutorial=== | ===Text Tutorial=== | ||
# Empty out Emboss barrels and cut from both sides (not including the pen tip) to about 4.2 cm. | # Empty out Emboss barrels and cut from both sides (not including the pen tip) to about 4.2 cm. | ||
# Attach the non-grooved/smooth part of the | # Attach the non-grooved/smooth part of the Supergrip on the Emboss barrels. | ||
# Cut 5 to 7mm of Hyperjell grip and attach to Emboss Barrels. (shown below, adding a single section of supergrip is optional for effect)<br>[[File:Kzznemboss1.jpg|left|thumb|200px]]<br clear=all> | |||
# Insert the G3 rubber inside the Dr. Grip tip. <br>[[File:Kzznemboss2.jpg|left|thumb|200px]]<br clear=all> | |||
# Cut the HGR pen's backcap by about 5 mm. | |||
==References== | |||
<references /> | |||
[[Category: Pen Mods]] | |||
Revision as of 05:03, 18 January 2021
Kzzn Emboss is a Double Sided mod created by JEB based spinner Kzzn.
Construction
Parts needed
- 2x Dr.Grip HDG-50R (tips)
- 4x Supergrip (grips)
- 2x Airblanc (tips)
- 2x HGR (backcaps)
- 1x Penzgear (rings)
- 2x Emboss (barrels)
- 2x G3 (rubber from caps)
- 1x Anyball (grips, two is optional)
- 1x Hyperjell (grip)
Text Tutorial
- Empty out Emboss barrels and cut from both sides (not including the pen tip) to about 4.2 cm.
- Attach the non-grooved/smooth part of the Supergrip on the Emboss barrels.
- Cut 5 to 7mm of Hyperjell grip and attach to Emboss Barrels. (shown below, adding a single section of supergrip is optional for effect)
- Insert the G3 rubber inside the Dr. Grip tip.
- Cut the HGR pen's backcap by about 5 mm.
