Neo Ivan Mod: Difference between revisions
From Fen Spinner Wiki
More actions
No edit summary |
Validate text tutorial against recovered source; clarify construction and add heading reference and sourced images |
||
| Line 23: | Line 23: | ||
* Tape | * Tape | ||
===Text tutorial=== | ===Text tutorial<ref>[https://penmodding.pm/archives/3017 Neo Ivan Mod tutorial]</ref>=== | ||
# Empty both SuperTips barrels. | |||
====Preparation==== | ====Preparation==== | ||
# Cut one St barrel to 4. | # Cut one St barrel to 4.5 cm from the back, then 4.5 cm from the front. | ||
# Cut | # Cut two 3 cm sections of silicone tubing. | ||
# Cut 2x | # Cut 2x 2 cm piece of pencil. | ||
====Assembly==== | ====Assembly==== | ||
# Assemble the front piece of the st barrel on the back of the st body which was not cut. Do the same for the back 4. | # Assemble the front piece of the st barrel on the back of the st body which was not cut. Do the same for the back 4.5 cm part. | ||
# Add some sticky paste inside the M6 nuts. | # Add some sticky paste inside the M6 nuts. | ||
# Put | # Put one 2 cm pencil section inside each barrel end (Wrap some tape if necessary). | ||
# | # Place the Nuts on both end, then cover both with the silicone tubes. | ||
==References== | ==References== | ||
<references /> | |||
[[Category:Pen Mods]] | [[Category:Pen Mods]] | ||
Latest revision as of 21:49, 2 October 2026
The Neo Ivan Mod is a double-sided mod made by PPP members: Aguia, Kad, and Furbeller. The Neo Ivan Mod was made as a cheap mod which could be easily recommended to beginners.
Construction
Parts needed
List from Penmodding.pm[1]
- x2 Crayola SuperTips / Carioca perfume (2 body)
- x1 Silicone Tube that fit on st body
- x2 cap nuts M6 Body
- x1 Pencil
Additional Items
- Sticky paste
- Tape
Text tutorial[2]
- Empty both SuperTips barrels.
Preparation
- Cut one St barrel to 4.5 cm from the back, then 4.5 cm from the front.
- Cut two 3 cm sections of silicone tubing.
- Cut 2x 2 cm piece of pencil.
Assembly
- Assemble the front piece of the st barrel on the back of the st body which was not cut. Do the same for the back 4.5 cm part.
- Add some sticky paste inside the M6 nuts.
- Put one 2 cm pencil section inside each barrel end (Wrap some tape if necessary).
- Place the Nuts on both end, then cover both with the silicone tubes.