Ivan Giotto: Difference between revisions
From Fen Spinner Wiki
More actions
No edit summary |
|||
| Line 27: | Line 27: | ||
# Cut the Giotto back plug from the ring. | # Cut the Giotto back plug from the ring. | ||
# Cut one of the two Giotto bodies in half. | # Cut one of the two Giotto bodies in half. | ||
# Cut both Dr. Grip grips in half and | # Cut both Dr. Grip grips in half and optionally cut the front to roughly the same size as the 2 Archery bullet tips | ||
====Assembly==== | ====Assembly==== | ||
Latest revision as of 11:36, 28 August 2026
The Ivan Giotto is a double-sided mod made by FPSB modder VoreTex. It was made for VicGotGame for his project: "X incipiens stabilus"[1].
Construction
Parts needed
Parts list from the video below:
- x2 Giotto Turbo Maxi (2 bodies, 2 back plugs)
- x2 Pilot Dr. Grip (grips; optional: fronts)
- x2 O-ring
- x2 Decorative grips (original use base of Z-grip and 4 O-rings for 1 side)
- x2 Archery bullet tips
=Additional items
- Tape
Text tutorial
Preparation
- Cut the front and disassemble both Giotto barrels.
- Cut the Giotto back plug from the ring.
- Cut one of the two Giotto bodies in half.
- Cut both Dr. Grip grips in half and optionally cut the front to roughly the same size as the 2 Archery bullet tips
Assembly
- Put one Giotto back plug in each hole of the uncut Giotto body.
- Add one O-ring on each back plug and connect the two halves of the cut Giotto barrel. (tape might be necessary to hold the parts well)
- Add some tape around the Archery bullet tip (connect with the Dr. Grip front, this should prevent the tips from falling).
- Put the Archery bullet tip in the Ivan Giotto base, it should fit snugly.
- Add the decorative grip, then add one half of a Dr. Grip grip.
- Repeat on the other side.
Video tutorial
Video tutorial by VoreTex.