Toro MX: Difference between revisions
From Fen Spinner Wiki
More actions
m →Text tutorial: Removed excessive redirect |
Apply independent tutorial corrections; retain disputed construction pending editor decision |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 8: | Line 8: | ||
|cog=? | |cog=? | ||
}} | }} | ||
The '''Toro | The '''Toro MX''' is a [[Single Sided]] mod created by [[JEB]] spinner Toro. This mod is a variation of the [[RSVP MX]] mod using [[Pilot SuperGrip]] and [[Pilot Hi-Tec-C]]. | ||
==Construction== | ==Construction== | ||
| Line 20: | Line 20: | ||
* Blu-tak/ teflon tape | * Blu-tak/ teflon tape | ||
* An insert | * An insert | ||
===Text | ===Text tutorial=== | ||
# Unscrew the tip from Hi-Tec-C pen. | # Unscrew the tip from Hi-Tec-C pen. | ||
# Remove RSVP | # Remove the RSVP cap, cut off its clip and smooth the cut. | ||
# Poke a hole in the RSVP backplug and insert the inktube into the pen backwards. | # Poke a hole in the RSVP backplug and insert the inktube into the pen backwards. | ||
# Remove RSVP | # Remove the RSVP grip and push it into the cap. | ||
# | # Fit the prepared cap to the rear of the barrel. | ||
# | # Fit the SuperGrip grip over the RSVP front. | ||
# | # Fit the Hi-Tec-C tip over the RSVP front, using adhesive putty or Teflon tape as needed to secure it. | ||
===Video Tutorial=== | ===Video Tutorial=== | ||
| Line 33: | Line 34: | ||
Video Tutorial by Oleg. | Video Tutorial by Oleg. | ||
==References== | |||
<references /> | |||
[[Category:Pen Mods]] [[Category:RSVP Mods]] | [[Category:Pen Mods]] [[Category:RSVP Mods]] | ||
Latest revision as of 22:38, 3 October 2026
The Toro MX is a Single Sided mod created by JEB spinner Toro. This mod is a variation of the RSVP MX mod using Pilot SuperGrip and Pilot Hi-Tec-C.
Construction
Parts needed
- 1x RSVP (Everything)
- 1x Pilot Hi-Tec-C (tip)
- 1x Pilot SuperGrip (Grip)
Additional Items
- Blu-tak/ teflon tape
- An insert
Text tutorial
- Unscrew the tip from Hi-Tec-C pen.
- Remove the RSVP cap, cut off its clip and smooth the cut.
- Poke a hole in the RSVP backplug and insert the inktube into the pen backwards.
- Remove the RSVP grip and push it into the cap.
- Fit the prepared cap to the rear of the barrel.
- Fit the SuperGrip grip over the RSVP front.
- Fit the Hi-Tec-C tip over the RSVP front, using adhesive putty or Teflon tape as needed to secure it.
Video Tutorial
Video Tutorial by Oleg.