Fly Emboss Private ver.: Difference between revisions
From Fen Spinner Wiki
More actions
m Copyedit: spelling and grammar |
Publish wording review of existing tutorial; retain construction without adding a source, per editor direction |
||
| Line 24: | Line 24: | ||
===Text tutorial=== | ===Text tutorial=== | ||
====Preparation==== | ====Preparation==== | ||
# Cut one Emboss body to 2x 4. | # Cut one Emboss body to 2x 4.2 cm (keep the front from one). | ||
# Cut the G2 grip to 4x flat stripe, 2x 2 section, and 2x 5 section. | # Cut the G2 grip to 4x flat stripe, 2x 2 section, and 2x 5 section. | ||
# Cut 2x 1 cm of Airblanc grip. | # Cut 2x 1 cm of Airblanc grip. | ||
| Line 36: | Line 36: | ||
# Add 1 cm of Airblanc grip on the hanging g2 section. | # Add 1 cm of Airblanc grip on the hanging g2 section. | ||
# Repeat on the other side. | # Repeat on the other side. | ||
==References== | ==References== | ||
Latest revision as of 17:28, 3 October 2026
 | This article contains leaked information from an anonymous source. The authenticity has been regarded as reasonable by Fenspinner Wiki, but cannot be guaranteed. Fenspinner Wiki has a policy of never disclosing the identity of leakers, and presents the information as-is. |
The Fly Emboss is a personal mod made by PSH spinner Fly. The original mod's tutorial was intended to be private, but Fly made a video of a "public" version showing an altered version of the mod.
Construction
Parts needed
- 2x Tsukineko Emboss Dual Pen (2 bodies)
- 4x Pilot G2 (4 flat sections and 2 striped sections)
- 2x Penzgear (6 metal rings)
- Presumed to be "Penzgear like rings", the original rings used may be different.
- 1x Pilot Airblanc (grip)
- 2x Plastic hole plug
Text tutorial
Preparation
- Cut one Emboss body to 2x 4.2 cm (keep the front from one).
- Cut the G2 grip to 4x flat stripe, 2x 2 section, and 2x 5 section.
- Cut 2x 1 cm of Airblanc grip.
Assembly
- Connect both Emboss parts to the uncut Emboss barrel.
- Add the grips in this order: 5 stripes of G2 grip, a flat section of G2 grip (no ring side first), and another G2 flat part half hanging (ring side first).
- Put 3 Penzgear type rings on the Plastic hole plug.
- Push the ring assembly inside the hanging G2 half.
- Add 1 cm of Airblanc grip on the hanging g2 section.
- Repeat on the other side.