Esaya Ivan: Difference between revisions
From Fen Spinner Wiki
More actions
Correct barrel joins and tip placement; specify mechanical-pencil Opt parts and outward smooth grip ends; embed compressed diagram. |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 12: | Line 12: | ||
===Parts needed=== | ===Parts needed=== | ||
Parts and construction from Penmodding.pm.<ref>[https://penmodding.pm/archives/6972 Esaya Ivan tutorial on Penmodding.pm]</ref> | |||
* 2x [[Crayola SuperTips|SuperTips]] (barrels) | * 2x [[Crayola SuperTips|SuperTips]] (barrels) | ||
* 2x [[Pilot Opt Shaker]] (tips, grips) | * 2x [[Pilot Opt Shaker]] (mechanical-pencil version; tips, grips) | ||
* 1x [[Dong-A Anyball|Anyball]] (grip) | * 1x [[Dong-A Anyball|Anyball]] (grip) | ||
===Text tutorial=== | ===Text tutorial=== | ||
====Preparation==== | ====Preparation==== | ||
# Cut | # Empty both SuperTips barrels. | ||
# From one barrel, cut a 4 cm rear section and a 4 cm front section, excluding the nib. Keep the other barrel uncut. | |||
# Cut two two-ring sections of Anyball grip. | |||
====Assembly==== | ====Assembly==== | ||
# | # Insert the cut front section into the rear of the uncut barrel. Fit the cut rear section over the front of the uncut barrel. | ||
# | # Fit an Anyball section onto each end, covering the barrel joints. | ||
# | # Fit an Opt grip onto each end, with its smooth end facing outwards. | ||
# Insert | # Insert an Opt mechanical-pencil tip into the exposed end of each Opt grip.<br>[[File:EsayaIvanAssembly.jpg|left|thumb|200px]]<br clear=all> | ||
==References== | ==References== | ||
<references /> | |||
[[Category:Pen Mods]] | [[Category:Pen Mods]] | ||
Latest revision as of 18:40, 1 October 2026
The Esaya Ivan is a personal mod made by JEB spinner Esaya.
Construction
Parts needed
Parts and construction from Penmodding.pm.[1]
- 2x SuperTips (barrels)
- 2x Pilot Opt Shaker (mechanical-pencil version; tips, grips)
- 1x Anyball (grip)
Text tutorial
Preparation
- Empty both SuperTips barrels.
- From one barrel, cut a 4 cm rear section and a 4 cm front section, excluding the nib. Keep the other barrel uncut.
- Cut two two-ring sections of Anyball grip.
Assembly
- Insert the cut front section into the rear of the uncut barrel. Fit the cut rear section over the front of the uncut barrel.
- Fit an Anyball section onto each end, covering the barrel joints.
- Fit an Opt grip onto each end, with its smooth end facing outwards.
- Insert an Opt mechanical-pencil tip into the exposed end of each Opt grip.
