View source for PK G3 Mod (Love mod)

{{Mod Infobox
|name=
|image={{#setmainimage:PKG3LoveMod.jpg}}
|creator= Peda
|style= [[Single Sided]]
|length= 21cm
|weight= 18.5g
|cog=
}}
The '''PK G3 Mod (Love mod)''' is a single-sided mod by Peda, built around a Pilot G3 barrel with a custom front assembly and a Hyperjell cap at the rear. It measures 21 cm and weighs 18.5 g.<ref name="PM">[https://penmodding.pm/archives/1921 PenModding PM, “PK G3 Mod (Love mod)” (accessed 3 October 2026)]</ref>

==Construction==

===Parts needed===
* 1x [[Pilot G3]] (barrel, tip, and ink tube; remove its grip and omit the backcap)
* 1x Hyperjell (cap and grip)
* 2x [[Hybrid Gel Grip|HGG]] (two grips and one tip)
* 1x Faber-Castell Grip Matic (tip)
* 1x Pilot G2 (front section)
* 1x Signo RT (grip)
* 2x Penwish rings
* 1x Signo Broad (grip)
* 1x [[Dong-A Anyball|Anyball]] grip
* Insert (type and fit unspecified) <ref name="PM" />

===Text Tutorial===
# Remove the G3 grip, file down the square ridges, and trim the barrel just behind its raised bump. Add tape at the rear to help retain the Hyperjell cap.
# Prepare the G2 front section to about 2.8 cm, then file its outside diameter until it fits the G3 barrel.
# Place the G3 ink tube inside the barrel and use tape to secure the front and rear interfaces.
#:[[File:PM-P1921-Tutorial-01.png|frameless|400px|G3 ink tube taped at the front and rear.]]
# Trim one HGG grip to its ring and cut the second to about 2 cm from its ring. Arrange the two grips at the front and wrap tape so the G3 tip seats firmly.
#:[[File:PM-P1921-Tutorial-02.png|frameless|400px|HGG grips fitted at the front of the G3 body.]]
# Cut the Signo RT grip into a 2.9 cm main section and a shorter piece beginning at 1.2 cm, as illustrated. Cut the Hyperjell grip to 2.8 cm.
# Layer the small Signo RT section, Penwish rings, short grip piece, remaining Signo RT grip, HGG ring, and two Anyball stripes in the illustrated order.
# Cut a 0.7 cm ink-tube segment and fit it into the HGG tip. Tape its other end so it can be retained by the Grip Matic tip.
# Remove and file the Hyperjell cap clip. Fit the front assembly into the cap, then add the 2.8 cm Hyperjell grip and a 0.4 cm Signo Broad grip section.
# Add an insert to the G3 barrel and fit the Hyperjell cap. <ref name="PM" />

==References==
<references />

[[Category:Pen Mods]] [[Category:G3 Mods]]